15
2. Place four M8 screws and four washers over the threaded inserts,
as shown in the diagram above, and tighten the screws to mount
the bracket. Make sure the screws are tightened and the bracket is
ush and secure.
NOTE: We recommend applying torque of 140 in-lb (16Nm) to the
screws.
4.1.2 Installation With Drilling Holes Using a Template
1. Find a proper location on your boat to drill holes. The typical
suggested location is the end of the boat/kayak.
2. Drill holes 0.31in (8 mm) in diameter.
3. Place the bracket above the drilled holes, align the holes on the
bracket with the drilled holes.
4. Place four M8 screws with washers over the holes, and four
washers with four nuts beneath the holes, and tighten the screws
to secure the bracket. Make sure the screws are tight and the
bracket is ush on the deck and secure.
NOTE: We recommend to apply a torque of 140 in-lb (16Nm) to the
screws.
M8 screw
M8 washer
M8 nut
To Next Page
Loading...