29
4.6 Adjust the Motor Trim Angle
You can adjust the angle between water surface and the motor using
the motor trim angle adjustment design. Follow the steps below if you
would like to change the angle of the motor.
1. Tilt the motor up and hold it rmly.
2. Remove the R shaped cotter pin from the trim rod and pull the trim
rod out from the current trim position of the bracket.
3. Adjust the motor to the desired angle.
4. Reinsert the trim rod through one of the four positions on the
bracket, and insert the R shaped cotter pin to secure the trim rod.
NOTE: Be careful of nger pinching. You can use a at head screw
driver or needle nose pliers to help remove the cotter pin.
Trim rod
Four trim
positions
To Next Page
Loading...