19
4.3.1 Setup With Control Cords at the Top
If you have a kayak setup with control cords running on the top of the
kayak, follow the steps below to nish the motor control cords setup:
1. Assemble the swing arm and steering triangle as shown above,
then insert the screw, washer, and nut as shown and attach
loosely- don’t tighten yet.
2. Place the screw, washer and nut on the clamping ring as gure
shows, connect them loosely and don’t tighten yet.
M6 screw Washer M6 nut
M6 screw
Washer
M6 nut
Swing arm
To Next Page
Loading...