Newport NK180 - Installation with an Adapting Plate

16
Dierent kayaks may require dierent installation hardware. If your
kayak requires installation hardware other than what is included in
this kit, please nd it at your local hardware store. Newport Vessels
does not carry every possible hardware combination necessary to t
all brands and models of kayaks; however any additional mounting
hardware needed for your individual craft should be standard, easy to
nd, and low-cost.
4.1.3 Installation With an Adapting Plate
1. Place the bracket above the adapting plate and align the holes on
the adapting plate with the holes on the bracket.
2. Place four M8 screws and four washers over the holes, four
washers and four nuts beneath the holes, and tighten the screws
to secure the bracket. Make sure the screws are tight and the
bracket is secure.
3. Install the adapting plate in the intended location and make sure
the adapting plate is correctly installed and secure.
NOTE: We recommend to apply a torque of 140 in-lb (16Nm) to the
screws.
M8 screw
M8 washer
M8 nut