Newport NK180 - Setup with Control Cords at the Bottom

21
4.3.2 Setup With Control Cords at the Bottom
If the kayak control cords come out under the position of the
supporting drum, follow the steps below to nish the motor control
cords setup:
1. Assemble the swing arm and clamping ring as the gure shows,
then insert the screw, washer, and nut, as shown. Connect them
loosely but don’t tighten yet.
2. Place the screw, washer and nut on the steering triangle as the
gure shows and connect them loosely, but don’t tighten yet.
M6 screw
Washer M6 nut
Steering triangle
M6 screw Washer M6 nut
Clamping ring
Swing arm