22
3. Slide the preassembled steering triangle onto the motor shaft.
4. Insert the motor shaft into the motor supporting drum as shown.
5. Slide the preassembled clamping ring onto the motor shaft above
the supporting drum as shown.
6. Make sure the steering triangle is aligned with the direction of the
motor. If the triangle is an arrow, it should point towards the front
of the boat, while the propeller should face back.
7. Tighten the screws on the clamping ring and the steering triangle.
In this setup, the clamping ring determines the depth of the motor,
so make sure the propeller can be at least 2 inches (5 cm) below the
water surface.
NOTE: Before stowing the motor, loosen the steering cord to give
some extra length in the cord, otherwise the cord S-biner will break.
(This is true only for this conguration.)
Motor shaft
Swing arm
Steering triangle
Direction cords
at the bottom
Clamping ring
To Next Page
Loading...