Newport NK180 - Adjusting Motor Depth of Water after Setup; Connecting the Cords; Cables to Control the Direction

24
4.3.4 Adjusting Motor Depth of Water After Setup
1. Hold the motor rmly and loosen the screw on either the clamping
ring or the steering triangle, whichever is topmost on the shaft in
your set up.
2. Adjust shaft position to nd the optimum motor depth in water.
3. Tighten the screws on the clamping ring or the steering triangle
(whichever you have on the top of the shaft).
NOTE: Be aware, the screw on the steering triangle or the clamping
ring must be tightened well, otherwise the motor may fall into the
water!
4.3.5 Connecting the Cords
4.3.5.1 Cables to Control the Direction
1. Secure the cable on one side of the stainless steel biner.
2. Attach the stainless steel biner to the steering triangle.
Directional control has 4 options to adjust
steering tment, feel and sensitivity