SHAPING THE FUTURE SATELLITE OF COMMUNICATIONS
6.4.2.4 Changing Parameters
To change parameters log in as administrator.
Use one of the following methods to change the parameters.
• Using the editable parameters in the functional blocks (used to edit the common
used functions);
• Using the tree structure parameter pages.
To create a new configuration, the easiest way is to use the Wizard. The Wizard is
only applicable for users with an expert profile. It is highly recommended to perform
a configuration reset to clear the existing configuration before using the Wizard.
Experienced users can adjust parameters in the tree tab.
Proceed as follows to adjust parameters:
1. Click the Overview tab or the Tree tab;
2. Two possibilities:
- The Overview tab, click the detailed view icon (
) of the functional
block that contains the parameter(s) to be adjusted;
- The Tree tab, navigate to the parameter page that contains the
parameter(s) to be adjusted;
3. Click the Editable icon (
) next to the parameter;
4. Insert or choose the new parameter value;
5. Save the parameter value;
6. Edit more parameters in the same way if needed.
7. Save the new configuration.
6.4.3 Setup Wizard
The wizard helps to setup the device for the first time.
To start up the wizard proceed as follows:
Click Misc. > Wizards
The following screens are displayed:
To Next Page
Loading...
