PSM1700 PsimetriQ user manual
i
IMPORTANT SAFETY INSTRUCTIONS
This equipment is designed to comply with BSEN 61010-1
(Safety requirements for electrical equipment for
measurement, control, and laboratory use) – observe the
following precautions:
Ensure that the supply voltage agrees with the rating of
the instrument printed on the back panel before
connecting the mains cord to the supply.
This appliance must be earthed. Ensure that the
instrument is powered from a properly grounded supply.
The inputs must not be connected to signals greater
than 50V rms or 100V pk.
Keep the ventilation holes on the underneath and sides
free from obstruction.
Do not operate or store under conditions where
condensation may occur or where conducting debris
may enter the case.
There are no user serviceable parts inside the
instrument – do not attempt to open the instrument,
refer service to the manufacturer or his appointed
agent.
Note: Newtons4th Ltd. shall not be liable for any
consequential damages, losses, costs or expenses
arising from the use or misuse of this product
however caused.