Need help?Do you have a question about the NexComm Systems NEXPEED NBG440 and is the answer not in the manual?
General| Brand | NexComm Systems |
|---|---|
| Model | NEXPEED NBG440 |
| Category | Network Router |
| Connectivity Technology | Wireless |
| Data Link Protocol | Ethernet, Fast Ethernet, IEEE 802.11b, IEEE 802.11g |
| Frequency Band | 2.4 GHz |
| Wireless Protocol | 802.11b/g |
| Wireless Standards | IEEE 802.11b, IEEE 802.11g |
| Wireless Speed | 54 Mbps |
| Ports | 1 x WAN / 4 x LAN |
| Encryption Algorithm | WEP, WPA, WPA2 |
| Features | Firewall, NAT |
| Type | Wireless |
| Antenna | 2 x External |
Details the router's capabilities, including SHDSL, IP routing, and Ethernet switching.
Lists hardware and software specifications like memory, data rates, protocols, and management options.
Details the setup of the SHDSL port, including Annex, wire mode, and rate.
Covers assigning IP addresses, IP unnumbered, and multiple IP addresses to interfaces.
Details enabling/disabling bridging, interface modes, and bridge table verification.
Describes adding/deleting static routes, default gateways, and viewing the routing table.
Covers setting up DHCP relay service and configuring the NBG440 as a DHCP server.
Explains Network Address Translation (NAT) and Port Address Translation (PAT) for IP address mapping.
Provides steps for upgrading the router's firmware using TFTP.
Demonstrates connecting two NBG440 routers using 4-wire SHDSL in bridging mode.
To Next Page