NexComm Systems NEXPEED NBG440 User Manual

NEXPEED NBG440 User’s Manual
NexComm Systems, Inc. 24 PAGE
s1 gshdsl(ANNEX-A) RT 4wire
mx0 bind = { }
(conf)#
Using gshdslset Commands
If you type the following command, it displays gshdslset help commands.
COMMAND (conf)# gshdslset help
Usage Examples:
(conf)# gs help
Usage:gshdslset margin <0 ~ 15> <ifname>
gshdslset backoff enable|disable <ifname>
gshdslset bert <seconds> <ifname>
gshdslset bert show
(conf)#
Monitoring the SHDSL port
Use the gshdslset command to display the status of a G.SHDSL physical port on the
router.
COMMAND (conf)# gshdslset
Usage Examples:
(conf)# gs
G.SHDSL R2.0(A.233.1.21) Device Driver, (16:53 02/27/2004) ☞ chipset information
-------------------------------------------------------
Line # 0 1 ☞ Index of SHDSL port
-------------------------------------------------------
Side RT RT ☞ Equipment Type
Mode ADAPTIVE ADAPTIVE ☞ Rate Mode
OP state [Data] [Data] ☞ Operating Status
SYNC status sync sync ☞ SYNC Status (none/ sync)
rate(kbps) 2320 2320 ☞ Actual bit rate
Tx Power 7 7 ☞ Transmit Power
LoopAtten(dB) 0 -1 ☞ Loop Attenuation
SNR(dB) 37 38 ☞ Received signal-to-noise ratio(SNR)
SMargin (dB) 6 6 ☞ startup margin value
(conf)#

NexComm Systems NEXPEED NBG440 Specifications

General

Brand	NexComm Systems
Model	NEXPEED NBG440
Category	Network Router
Language	English