11.
When installing on the floor, position the unit in the
desired position and secure the unit with plug and
screw supplied.
12.
When installing on the wall, hang the unit on the
wall bracket according to the image below, and se-
cure the unit with the supplied plug and screw.
13.
Remove the cover to access the terminal block as il-
lustrated.
14.
Connect the cables to the terminal block. Secure the
cable using the cable tie. Also see section "Electrical
connection" on page 8.
WARNING!
Ensure that all connections are tightened
properly on the terminal block. Incorrectly
tightened terminals lead to overheating,
problems with the heat pump's function
and are a fire risk.
AG-WL10Chapter 5 | Installation12
To Next Page
Loading...
