Item register
A
Accessibility, electrical connection, 19
Accessories, 47
Alarm, 45
Assembly, 6
B
Back button, 30
Brine side, 14
C
Cable lock, 20
Commissioning and adjusting, 25
Filling and venting, 25
Post adjustment and bleeding, 27
Preparations, 25
Start guide, 26
Connecting accessories, 24
Connecting external operating voltage for the control system, 20
Connecting the climate system, 15
Connecting the hot water heater, 15
Connections, 20
Contact for activation of “external adjustment", 24
Contact for activation of “temporary lux", 23
Contact for external tariff blocking, 23
Control, 30, 34
Control - Introduction, 30
Control - Menus, 34
Control - Introduction, 30
Display unit, 30
Menu system, 31
Control knob, 30
Control - Menus, 34
Menu 5 - SERVICE, 35
Cooling section, 11
D
Data for energy efficiency of the system, 53
Delivery and handling, 6
Assembly, 6
Drawing out the cooling module, 6
Installation area, 6
Removing parts of the insulation, 8
Removing the covers, 7
Supplied components, 7
Transport, 6
Dimensions and pipe connections, 14
Dimensions and setting-out coordinates, 48
Display, 30
Display unit, 30
Back button, 30
Control knob, 30
Display, 30
OK button, 30
Status lamp, 30
Switch, 30
Disturbances in comfort, 45
Alarm, 45
Manage alarm, 45
Troubleshooting, 45
Docking alternatives, 15
Extra electric hot water heater, 16
Free cooling, 16
Ground water system, 16
Neutralization vessel, 15
Under floor heating systems, 17
Ventilation recovery, 16
Draining the climate system, 39
Draining the hot water heater, 39
Drawing out the cooling module, 6, 40
E
Electrical addition - maximum output, 21
Setting max electrical output, 21
Switching to maximum electrical output, 21
Electrical cabinets, 10
Electrical circuit diagram, 57
Electrical connections, 18
Accessibility, electrical connection, 19
Cable lock, 20
Connecting accessories, 24
Connecting external operating voltage for the control system, 20
Connections, 20
Electrical addition - maximum output, 21
External connection options, 22
General, 18
Miniature circuit-breaker, 18
Motor cut-out, 18
Optional connections, 22
Outdoor sensor, 21
Power connection, 20
Removing the cover, base board, 19
Removing the cover, immersion heater circuit board, 19
Removing the hatch, input circuit board, 19
Settings, 21
Standby mode, 21
Temperature limiter, 18
Emptying the brine system, 40
Energy labelling, 52
Data for energy efficiency of the package, 53
Information sheet, 52
Technical documentation, 54
External connection options, 22
Contact for activation of “external adjustment", 24
Contact for activation of “temporary lux", 23
Contact for external tariff blocking, 23
Possible selection for AUX inputs, 22
Switch for "Smart Grid ready", 23
Switch for external blocking of addition and/or compressor, 23
Switch for external blocking of heating, 23
Switch for external forced control of brine pump, 23
Temperature sensor, external flow line, 23
Temperature sensor, hot water top, 22
F
Filling and venting, 25
Filling and venting the brine system, 25
Filling and venting the climate system, 25
Filling the hot water heater, 25
Symbol key, 26
Filling and venting the brine system, 25
Filling and venting the climate system, 25
Filling the hot water heater, 25
H
Heating medium side, 15
Connecting the climate system, 15
Helping the circulation pump to start, 40
Help menu, 26, 33
Hot water heater, 15
Connecting the hot water heater, 15
I
Important information, 4
Recovery, 4
Information sheet, 52
Inspection of the installation, 5
NIBE F1226Chapter 13 | Item register62
13 Item register
To Next Page
Loading...
Need help?
General
