Nice 7251 - Instruction 15: Select Control Board Standby Mode

7251 / 7351 Slide Gate Operator
INSTALLATION AND PROGRAMMING MANUAL
32
STANDBY MODE puts the board into a “Low Power Consumption
Standby Mode”. Press any button to “wake” the board. Select ON
or OFF as follows:
1. Press FUNCTIONbutton.
2. Scroll to "Standby" menu (8th menu).
3. Press OK. 
4. Use UP and DOWN buttons to select desired amount of time
before system enters "Standby Mode". 20-30 seconds is the
recommended setting.
5. Press OK.
6. Once this is done, the operator will enter a Standby Mode after the set time when the operator is
not moving, it is either in the auto-close countdown or is being held open by an external auxiliary
input.
SELECT CONTROL BOARD STANDBY MODE
15
NOTES:
When display is OFF
In Standby Mode only a
“heartbeat” will be present
at the OK LED.
Voltage at terminal #20 (24
volts) and terminal #38 (12
volts) will turn off - do not
power entry or exit devices
from this output.
BlueBUS function is disabled
until board "wakes" up.
Press any button to wake.
IMPORTANT!
For SOLAR APPLICATIONS - Turn the Standby Mode ON.
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com