Nice 7251 - Communications Buses

7251 / 7351 Slide Gate Operator
INSTALLATION AND PROGRAMMING MANUAL
67
OVIEW
CONTROLLER
15.3 COMMUNICATIONS BUSES
The 1050 control board communication bus is described in this section.
OVIEW CONTROLLER:
• The Oview controller is an optional programming and diagnostic tool, which plugs
directly into the 1050 control board using an RJ45 network cable and is part of the Nice
“Opera” control system.
• The Oview controller can be used in “stand-alone” mode via its front-panel keypad.
• This unit, when matched with the optional Oview Bluetooth module (OVBT; see below)
enables remote control and management of the gate controller.
• Remote control functions include most of the programming functions that are available
at the front panel LCD on the control board.
OVBT MODULE:
The optional OVBT Bluetooth module is used with the Oview controller for localized wireless
control of the gate controller.
OPTIONAL
OVBT
MODULE
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com