To Next Page

To Previous Page

16 – ENGLISH

PROGRAMMING

7 PROGRAMMING

There are 3 buttons on the control unit:

and

(“Figure

23”) which can be used both to command the control unit during

the testing phase and to programme the available functions.

FUSE

LED

FUSE

RECEIVER

L1 ... L8

The available programmable functions are grouped into two levels

and their operating status is signalled by eight LEDs “L1 ... L8”

located on the control unit (LED lit = function enabled; LED off =

function disabled).

7.1 USING THE PROGRAMMING BUTTONS

The button allows for commanding the door opening move-

ment, or shifting the programming point upwards.

Button used to stop a manoeuvre

If pressed for more than 3 seconds, it allows for entering the

programming mode.

The button enables the user to close the door or shift the

programming point downwards.

During the manoeuvre, whether opening or closing is irrele-

vant, all the buttons perform the STOP function and stop the

motor’s movement.

Nice SO2000 Instructions And Warnings For Installation And Use

Other manuals for Nice SO2000