8 – ENGLISH
3.6 INSTALLING THE GEARMOTOR
a
Incorrect installation may cause serious physical
injury to the person working on the system or to its
future users.
Before starting to assemble the automation, com-
plete the preliminary checks described in the “Pre-
installation checks” and “Product usage limits”
paragraphs.
a
The automation must be installed EXCLUSIVELY
WITH THE DOOR CLOSED.
To install SO2000:
1. insert the output shaft (A) into the transmission shaft (B) of
the door, coupling them with the aid of the key (C) provided
B
C
A
6
2. fasten the bracket (E) to the gearmotor (D) using the screw,
nut and washer provided
D
E
7
3. fasten the bracket (E) to the wall using wall plugs (not sup-
plied) suited to the wall’s material
E
8
4. SO2000 can be installed in the horizontal position using the
release mechanism (F), supplied with the kit, which must be
fastened with the three screws in the position shown, while
making sure that the unlocking cables (G) are fed through.
D
G
F
9
To Next Page
Loading...
Need help?
General
