Nice Titan 912L - 1050 Control Board Wiring: Push-To-Open

TITAN 912L Linear Actuator
Installation Reference Manual
1818
IMAGE 9D-2: 1050 BOARD - PUSH-TO-OPEN - SINGLE GATE
IMAGE 9D-1: 1050 BOARD - PUSH-TO-OPEN - SINGLE GATE
9D
1050 CONTROL BOARD WIRING: PUSH-TO-OPEN
5.4 1050 CONTROL BOARD WIRING: PUSH-TO-OPEN
YELLOW
YELLOW YELLOW
GREEN
GREEN GREEN
BLUE
BLUE BLUE
ORANGE
ORANGE ORANGE
WHITE
WHITE WHITE
BLACK
BLACK BLACK
RED
RED RED
WIRE 2nd ACTUATOR
WITH LONGER HARNESS
TO MOTOR 2
IMPORTANT!
For dual gate systems, wire the 2nd
harness into the connector, but do
not connect it to the control board
yet. It will be connected at a later step.
NOTICE
’ If gate moves opposite direction from expected, reverse red & black wires in that motor connector.
’ In dual gate systems, the longer actuator cable is usually connected to MOTOR 2.
MOTOR 1
MOTOR 1
MOTOR 1
MOTOR 1
MOTOR 2
MOTOR 2
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com