26 Unidrive M/HS Frame 5 to 6 Power Installation Guide
Issue Number: 9
3.3.2 Removing the finger-guard and DC terminal cover break-outs
Figure 3-6 Removing the finger-guard break-outs
A: All sizes. B: Size 5 only. C: Size 6 only.
Place finger-guard on a flat solid surface and hit relevant break-outs with hammer as shown (1).
Continue until all required break-outs are removed (2). Remove any flash / sharp edges once the
break-outs are removed.
To Next Page
Loading...
