Nidec F600 - Page 36

35 F600 Step By Step Guide
00.017
Motor thermal
protection
enable
29.087 OFF (0) or ON (1) OFF (0)
00.018
Reverse
output phase
sequence
5.042 OFF (0) or ON (1) OFF (0)
00.019
(RFC-S
mode
only)
Sensor-less
mode filter
3.079
4 (0), 8 (1),
16 (2),
32 (3),
64 (4) ms
4 (0) ms
00.020 0.000
00.021
Pump control
mode
29.011
Single Pump (0), Cascade (1),
Multi leader (2)
Single Pump (0)
00.022
Maximum
reference
clamp
1.006
VM_NEGATIVE_REF_CLAMP1[MIN] to
VM_NEGATIVE_REF_CLAMP1[MAX]
Std: 50 Hz
US: 60 Hz
Std: 1500.0 rpm
US: 1800.0 rpm
00.023
Positive
minimum
reference
clamp
1.004
VM_SPEED_FREQ_REF[MIN] to
VM_SPEED_FREQ_REF[MAX]
0.0 Hz 0.0 rpm
00.024
Control input
mode
29.012
Input (0), Input & Keypad (1), Ctrl Wrd (2),
Ctrl Wrd & Input (3)
Input & Keypad (1)
00.025
Hand mode
reference
select
29.016 Digital Speed (0), Analog Speed (1) Digital Speed (0)
00.026
Hand mode
frequency/
speed
reference
1.022
VM_SPEED_FREQ_REF[MIN] to
VM_SPEED_FREQ_REF[MAX]
Std:25 Hz
US:30 Hz
Std: 750 rpm
US: 900 rpm
00.027
General
acceleration
rate 1
2.011
VM_ACCEL_RATE[MIN] to
VM_ACCEL_RATE[MAX] s
1.0 s 1.000 s
00.028
General
deceleration
rate 1
2.021
VM_ACCEL_RATE[MIN] to
VM_ACCEL_RATE[MAX] s
1.0 s 1.000 s
00.029 PID setpoint 0 29.022 0.00 to 327.67 UU 0.00 UU
00.030
PID feedback
min scaling
29.031 0.00 to 327.67 UU 0.00 UU
00.031
PID feedback
max scaling
29.032 0.00 to 327.67 UU 100.00 UU
00.032
PID feedback
filter time
constant
29.033 0.00 to 327.67 s 1.00 s
00.033
PID feedback
loss action
29.048 Ignore (0), Trip (1), Fixed Speed (2) Trip (1)
00.034
PID feedback
high trip
threshold
29.041 0.00 to 327.67 UU 0.00 UU
00.035
PID feedback
low delay
29.042 0.0 to 6553.5 s 5.0 s
00.036
PID feedback
low mode
29.043 Disabled (0), Threshold (1), Bandwidth (2) Disabled (0)
00.037
PID feedback
low threshold
29.044 0.00 to 327.67 UU 2.00 UU
Parameter Range Default
Description OL RFC-A RFC-S OL RFC-A RFC-S