202
Technical Notes
Troubleshooting
The camera
cannot focus.
• The subject is too close. Try shooting using the Scene auto
selector or Close-up scene mode, or the macro close-up
focus mode.
• Incorrect focus mode setting. Check or change the setting.
• The subject is hard to focus on.
• Set AF assist in the setup menu to Auto.
• Subject is not in focus area when the shutter-release button
is pressed halfway.
• The focus-mode selector is set to r (manual focus).
• Turn the camera off and then on again.
• The camera may move slightly when operated, even if it is
attached to a tripod, which may interfere with the autofocus.
31, 34,
36, 54,
62
61
65
113,
172
24, 140
67
–
23
Colored stripes
appear on the
screen when
shooting.
Colored stripes may appear when shooting subjects with
repeating patterns (such as window blinds); this is not a
malfunction.
The colored stripes will not appear in captured images or
recorded movies. However, when using Continuous H: 120
fps or HS 480/4×, the colored stripes may be seen in the
captured images and recorded movies.
–
Images are
blurred.
• Use the flash.
• Enable vibration reduction.
• Use a tripod to stabilize the camera (using the self-timer
setting of n10s (10 seconds) at the same time is more
effective).
25, 55
154,
171
23, 58
Bright specks
appear in
images
captured with
flash.
Flash is reflecting off particles in air. Lower the built-in flash. 25, 55
Flash does not
fire.
• The built-in flash is lowered.
• A shooting mode where the flash cannot fire is selected.
• A function that restricts the flash is enabled.
25
73
75
Digital zoom
cannot be used.
• Digital zoom is set to Off in the setup menu.
• Digital zoom cannot be used with certain shooting modes
or when using certain settings in other functions.
113,
172
78, 172
Image size not
available.
• A func
tion that restricts the Image size option is enable
d.
• When the scene mode is set to Easy panorama, the image
size is fixed.
75
41
Problem Cause/Solution
A
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
