Inserting
the
Battery
Removing the Battery
Turn
the
camera
off
and confirm that the power-on
lamp
is
off
before removing the battery.
To
eject the
battery, open
the
battery-chamber/memory card slot
cover and slide the battery latch
in
the direction shown
CD.
The battery can then
be
removed by hand
0.
• Note that the battery may become
hot
during
use;
observe due caution when removing the battery.
Turning On and
Off
the
Camera
To turn on the camera, press the
power
switch. The
power-on lamp (green) will light and the
monitor
will
turn on.
To
turn
off
the camera,
press
the
power
switch
again.
If the camera
is
turned off, hold
down
[:EJ
to
turn the
camera on in playback
mode
(~
28).
~
Notes on
the
Battery
• Only
the
Rechargeable Li-io Battery
EN-ELS
ca
be used.
Do
not, under anycircumstances,
attempt
to use another
type
of
battery.
•
Be
sure
to
read and
follow
the
warnings for
the
battery
on
page iii and
the
section "Caring for
the
Camera"
(~
141), before
usi
ng
the
battery.
~
ACAdapter
The
AC
Adapter
EH~62A
(available separately
from
Nikon) can be used
to
power
the
COOLPIX
PS1
00
from
an electrical outlet. Do not,
under
any circumstances, use
another
make
or
model
of
AC
adapter. Failure
to
observe this precaution could result in overheating or in damage to
the
camera.
17
To Next Page
Loading...
