EasyManua.ls Logo

Nikon D70-series - Page 187

Nikon D70-series
221 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
177
Technical Notes—Optional Accessories
Optional Flash Units (Speedlights)
When used with a compatible device such as the SB-800, SB-600, and remote
SB-R200 Speedlights (available separately), the D200 supports the full range of
options available with the Nikon Creative Lighting System (CLS), including i-TTL
ash control ( 76), FV Lock ( 81), and Auto FP High-Speed Sync ( 160).
Support for Advanced Wireless Lighting allows the built-in fl ash to be used as a
commander unit for remote SB-800, SB-600, and SB-R200 Speedlights. See the
Speedlight manual for details. Note that the built-in Speedlight will not fi re when
an optional Speedlight is attached.
SB-800 and SB-600 Speedlights
These high performance Speedlights have Guide Numbers of 38/125 and 30/98
respectively (m/ft, 35-mm zoom head position, ISO 100, 20 °C/68 °F). The fl ash
head can be rotated through 90 ° above the horizontal, 180 ° left, and 90 ° right
for bounce-fl ash or close-up photography. The SB-800 can be rotated 7 ° below
the horizontal. Auto power zoom (24–105 mm and 24–85 mm, respectively) en-
sures that the illuminating angle is adjusted in accord with lens focal length. The
built-in wide panel can be used for an angle of 14 mm (the SB-800 also supports
17 mm). An illuminator is included to assist in adjusting settings in the dark.
SB-R200 Wireless Remote Speedlight
This high-performance wireless remote Speedlight has a Guide Number of 10/32
(m/ft, ISO 100, 20 °C/68 °F). Although it cannot be mounted on the camera ac-
cessory shoe, the SB-R200 can be fi red using an optional SB-800 Speedlight or
SU-800 wireless Speedlight commander, or a camera with Advanced Wireless
Lighting and a built-in fl ash. With the D200 in commander mode (
163), the
SB-R200 serves as a remote fl ash. It can held by hand, placed on an AS-20 Speed-
light stand, or mounted on the camera lens using the SX-1 attachment for re-
mote control and close-up i-TTL photography.
Use Only Nikon Flash Accessories
Use only Nikon Speedlights. Negative voltages or voltages over 250 V applied to the ac-
ces so ry shoe could not only prevent normal operation, but damage the sync cir cuit ry of
the camera or fl ash. Be fore us ing a Nikon Speed light not listed in this section, con tact a
Nikon-au tho rized ser vice rep re sen ta tive for more information.

Table of Contents

Related product manuals