Notes on Handling the Microscope System
9
Two clamp screws for the eyepiece tube mount part front side (long type) x2
Two clamp screws for the eyepiece tube mount part rear side (short type) x2
Sixteen clamp screws for base auxiliary legs x16
Sixteen washers for base auxiliary legs x16
• Sliding nosepiece x1
• LWD condenser
Main body x1
Two diaphragms for the diagonal illumination x2
• Polarizer turret
Main body x1
1/4 lambda plate positioning tool x1
• Polarizer for visible lights x1
• Polarizer for infrared rays x1
• Variable magnification double port tube x1
• Single objective holder x1
• LWD 16x water immersion type objective x1
• LWD 16x DIC slider x1
• Variable magnification turret x1
• Rectangular stage
Stage main part x1
Two auxiliary support columns x2
Two auxiliary plates x2
Knurled ring x1
Acrylic chamber x1
Chamber holder x1
Eight flat head screws to clamp auxiliary plates x1
• Lamp house adapter
Main body x1
Raising parts x2
• Precentered lamp house x1
• Magnescale
Main body x1
Display part x1
• AC adapter x1
2) Do not discard the packing case, as it may be needed for future transportation.
To Next Page
Loading...
Need help?
General
