The “Connect to Computer” Camera Control Display
The [Connect to comput
er] display shows the following:
Status: The status of the connection t
o the host. The profile name is displayed in green when
a connection is established. Errors are also displayed here (
0 367).
Signal strength: The wir
eless signal strength. Ethernet connections are shown by d.
Band: The band used by the wireless network to which the camera is connected in
infrastructure mode.
D Loss of Signal
Loss of signal while the camera is connected to a wireless network may disrupt the connection to the
computer. Select [End current connection] for [Connect to computer]> [Network settings] in the
network menu before connecting to the network again. When the signal is re-established, the camera
will reconnect to the computer and resume upload of any pictures that have yet to be transferred.
Note that upload cannot be resumed if you turn the camera off before transfer is complete.
D Caution: Ethernet Networks
Do not disconnect the Ethernet cable during upload or while the camera is on.
D Caution: Wireless Networks
Response may slow on wireless networks.
366
What You Can Do When the Camera Is
Connected t
o a Computer or FTP Server
1
2
3
To Next Page
Loading...
