nilan VPL 28 User Manual

May be subject to change page 16 of 27
Week programme
The unit is equipped with 3 standardized week programmes. See page 17.
Anlægget er fra fabrikken indstillet til program 1.
In addition to these programmes it is possible to programme your own week programme which can
be one of the standard programmes with minor alterations.
” ” indicates that the menu point flashes and can be set to another value.
Use of t he CTS 600 panel :
- pr ess ESC t o go one st ep back i n t he menu
- pr ess qpt o move up or down i n a menu or t o
adj ust an act i vat ed menu
- pr ess ENTER t o act i vat e a menu
- pr ess ENTER t o conf i r m a menu
- pr ess OFF t o t ur n of f t he uni t
- pr ess ON t o t ur n t he uni t on
Once settings have been made for
Monday , the values can be copied
to any other day the same settings
are to apply using in the copy
function.
System operation in
accordance with main
menu settings
”PROG 1"
MO1 06.00
>3 < 21°C
”CLEAR”
TU1 06.00
>3 < 21°C
MO TU
COPY
ENTER
ENTER
ENTER
”PROG 2"
MO2 08.00
>1 < 17°C
”PROG
3"
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER ENTER
MO TU
”COPY”
TU WE
COPY
TU2-6
SELECT
OFF
ENTER
ENTER
MO4-6
MO3 AUS
>1 < 17°C
PROG 1
WEEK
PROGRAM
SELECT
”OFF”
SELECT
SELECT
SELECT
SELECT
SELECT
Here it is possible to make your own
programme or adjust one of the
standard programmes. If there is more
than one function at the same time only
the last one is active.
Here it is possible to
chose one of the 3
standard programmes.
The 3 programmes can
be altered but not deleted.
The original programme
can always be found.
Here it is possible to delete all
user made programmes. The unit
will continue in AUTO mode
without any week programme.
Figure 11: The ”Week program” menu

nilan VPL 28 Specifications

General

Brand	nilan
Model	VPL 28
Category	Thermometer
Language	English