Nilfisk-Advance Advance SC750 ST

Service Manual: SC750, SC800, SC 750 ST, SC800 ST
Form Number 56043150 Page 34
Additional Program Options
The following opons can be used to set user preferences.
LOCKOUT BRUSH PRE - - For disc brush decks only, it is possible to lock out either the Low or High Brush Pressure seng.
During normal operaon the pressure seng(s) that are locked out will not be able to be selected.
• NONE
• LOW
• HIGH
To change the seng:
1. Scroll through the menu using the Soluon Increase and Decrease switches unl you get to the desired value.
2. To save and go back to the main menu, press the scrub ON/OFF switch.
LOCKOUT SOL FLOWS - - It is possible to lock out any one or more of the Soluon Flow Rate sengs. During normal op-
eraon, the ow rate(s) that are locked out will not be able to be selected.
• NONE
• LOW
• MEDIUM
• HIGH
• LOW & MEDIUM
• LOW & HIGH
• MEDIUM & HIGH
To change the seng:
1. Scroll through the menu using the Soluon Increase and Decrease switches unl you get to the desired value.
2. To save and go back to the main menu, press the scrub ON/OFF switch.
RECOVER TANK FULL - – It is possible to enable or disable the Recovery Tank Full automac shuto feature. Enable
means that the automac shuto feature is turned on. The system will shut o the vacuum motor if it senses the tank
is full. Disable means that the automac shuto feature is turned o. The system will not automacally shut o the
vacuum motor if it senses the tank is full.
• ENABLED
• DISABLED
To change the seng:
1. Scroll through the menu using the Soluon Increase and Decrease switches unl you get to the desired value.
2. To save and go back to the main menu, press the scrub ON/OFF switch.