EasyManuals Logo

Nilfisk-Advance BR 652 User Manual

Nilfisk-Advance BR 652
Go to English
123 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
ENGLISH
USER MANUAL
16
9098684000(3)04/2016 A BR 652 - BR 752 - BR 752C
Available cylindrical brushes and their relevant application guides (suggestions only)
Models MAGNA GRIT 46 DYNA GRIT 80 MIDLITE GRIT 180 PROLENE PROLITE UNION MIX
General cleaning:
Concrete
Terrazzo oor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Squeegee installation
1. Install the squeegee (30) and fasten it with the handwheels (34), then connect the vacuum hose (31) to the squeegee.
2. With the handwheel (35), adjust the squeegee so that the rear blades (18) - in all its length - touches the oor and the front
blade is slightly detached from the oor.
Solution/clean water tank lling
NOTE
If the machine is equipped with EcoFlex™ system (optional) pour clean water in the tank, otherwise pour solution.
CAUTION!
Use only low-foam and non-ammable detergents, intended for automatic scrubber applications.
WARNING!
When using oor cleaning detergents, follow the instructions on the labels of the detergent bottles.
To handle oor cleaning detergents, wear suitable gloves and protections.
1. Open the plug (23).
2. (For machine without EcoFlex™ system)
Use the removable ller hose to ll the tank (22) with a solution suitable for the work to be performed.
Do not ll the tank (22) completely, leave a few inches from the edge of the plug (23).
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40 °C.
(For machine with EcoFlex™ system)
Fill the tank (22) with clean water by using the removable ller hose.
Do not ll the tank (22) completely, leave a few inches from the edge of the plug (23).
The water temperature must not exceed 40 °C.
Detergent tank lling
(For machine with EcoFlex™ system)
1. Open the cover (20) and check that the recovery tank (19) is empty, otherwise empty it with the drain hose (24).
2. Close the cover (20).
3. Carefully lift the tank assembly (44).
4. Open the detergent tank plug (42).
5. Fill the tank with a detergent suitable for the work to be performed (highly concentrated detergent).
Do not ll the detergent tank completely, leave a few inches from the edge.
NOTE
If the detergent tank is empty (in case of new system, system emptied for cleaning, etc.), in order to ll the hose quickly,
it may be useful to drain EcoFlex™ system once or several times (see the procedure in Maintenance chapter).
Drivers position adjustment
1. Adjust the height of the steering wheel (1) with the lever (2) and the height of the heel support (5) to reach a comfortable
position.

Table of Contents

Other manuals for Nilfisk-Advance BR 652

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance BR 652 and is the answer not in the manual?

Nilfisk-Advance BR 652 Specifications

General IconGeneral
BrandNilfisk-Advance
ModelBR 652
CategoryScrubber
LanguageEnglish

Related product manuals