CAUTION!
When draining the wastewater, the vacuum
tube for waste must be folded (A, Figure.
14) and lowered to a lower position (B,
Figure. 14), and then open the lid of the
vacuum tube for waste to drain the water.
Do not make the outlet of the vacuum tube
for waste face upward to drain the water
vertically. This is to avoid wastewater
spilling onto the operator.
6. Perform steps 1 to 4.
Solution/clean water tank emptying
7. Empty the solution tank with the hose (A, Figure. 15). After
working, rinse the tank with clean water.
AFTER USING THE MACHINE
After working, before leaving the machine:
1. Remove the brushes/pad-holders.
2. Empty the tanks (B and C, Figure. 15) as shown in the
previous paragraph.
3. Perform the daily maintenance procedures (see the
Maintenance chapter).
4. Store the machine in a clean and dry place, with the brushes/
pad-holders and the squeegee lifted or removed.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days,
proceed as follows:
1. Perform the procedures shown in After Using the machine
paragraph.
2. Disconnect the battery connector (38).
FIRST PERIOD OF USE
After the first 8 hours, check the machine fastening and
connecting parts for proper tightening and check the visible
parts for wear and leakage.
Figure 15
Figure 14
A
C
B
D
A
B
To Next Page
Loading...
Need help?
General
