25
DETERGENT TANK CLEANING
(For machines with Chemical Mixing System)
Clean the detergent tank (G, Figure. 24) as shown below:
1. Drive the machine on a level floor.
2. Turn the ignition key (A) to "0".
3. Open the cover (B) and check that the recovery water tank (C)
is empty; if necessary empty it with the drain hose (D). Close
the cover (B).
4. Carefully lift the tank (C).
5. Unscrew the plug (E) and disconnect the hose (F) from the
tank (G).
6. Remove the tank.
7. Wash the tank in the appointed disposal area.
8. Install the tank (G) and connect the hose (F).
9. After draining the detergent tank, drain the Chemical Mixing
System too by running the system with clean water only.
MACHINE WORKING HOUR CHECK
1. Turn the ignition key (A, Figure. 25) to "I".
2. Press the switch (B), the hour meter (C) begins to work and it
at the same time shows the total number of working hours
(scrubbing/drying) performed by the machine.
3. Release the switch (B).
4. Turn the ignition key (A) to "0".
To Next Page
Loading...
Need help?
General
