Nilfisk-ALTO SC100 User Manual

General Information
10
Service Manual – SC100 - Scrubtec 130
Troubleshooting
Trouble Possible Causes Remedy
The machine does not work. The power supply cable or the relevant plug is broken. Replace the cable.
The main switch is broken. Replace the switch.
The switch panel is broken. Replace the switch panel.
The function electronic board is broken. Replace the electronic board.
The parking position microswitch is broken. Replace the microswitch.
The motor is broken. Replace the motor.
The driving belts are broken. Replace the belts.
The dirty water vacuuming is insufcient. The recovery tank is full. Empty the tank.
The squeegee bars are dirty or the blades are worn or
damaged.
Clean and check the squeegee
bars.
The inspection compartment is dirty. Clean the compartment.
The vacuum hose is disconnected or dirty. Connect or clean the hose.
The air lter is dirty. Clean the lter.
The solution ow to the brush is
insufcient.
The solution lter is dirty. Clean the lter.
The dosing bridge are clogged. Clean the dosing bridge.
The solenoid valve is broken. Replace the solenoid valve.
The squeegees leave marks on the oor. There is debris under the squeegee blades. Remove the debris.
The squeegee blades are worn, chipped or torn. Replace the blades.

Nilfisk-ALTO SC100 Specifications

General

Brand	Nilfisk-ALTO
Model	SC100
Category	Scrubber
Language	English