Nilfisk-ALTO SC100 User Manual

Solution System 28Service Manual – SC100 - Scrubtec 130
Solution System
Maintenance and Adjustments
Cylindricalbrush,brushcompartmentand
dosing bridge cleaning
1. Lower the machine to reach the lower side of the
cleaning deck.
2. Turn the lever (A) counter-clockwise and remove
the brush.
3. Clean and wash the cylindrical brush with water
and detergent.
4. Check the brush bristles for integrity and wear;
if necessary, replace the brush.
5. Carefully clean the brush compartment (B).
6. Disassemble the dosing bridge (C) and clean
them with water and detergent, then rinse and
reassemble in the relevant housings.
7. Install the cylindrical brush on the drive hub (D)
and engage it by turning the lever (E) clockwise.
Solutionltercleaning
1. Remove the tank assembly from the machine
body.
2. Remove the two rubber gasket (A and B), then
remove the lter strainer (C).
3. Clean and install them on the support (D).
AE
D
B
C
A
B
C
D

Nilfisk-ALTO SC100 Specifications

General

Brand	Nilfisk-ALTO
Model	SC100
Category	Scrubber
Language	English