Nilfisk-ALTO SCRUBTEC R 571 User Manual

Nilfisk ALTO Operator's Manual -
SCRUBTEC R Manual SteeringSCRUBTEC R Manual Steering
SCRUBTEC R Manual SteeringSCRUBTEC R Manual Steering
SCRUBTEC R Manual Steering Page -15-
How To Install The Brush Or Pad on the BOOST
machine
To install the brush or pad on the BOOST machine, follow
this procedure:
1. Turn the key switch "ON".
2. Put the brush switch in the "UP" position.
3. Turn the key switch "OFF".
4. Go to the side of the machine.
5. Press on a brush or pad under the flex plates. See
figure 15.
NOTE: When using a black pad, position pad on
head. Lower head and operate momentarily to affix
pad to pad driver (if you have difficulty, position pad
on floor and lower head then operate.)
How To Remove The Brush Or Pad on the BOOST
machine
To remove the brush or pad from the machine, follow this
procedure:
1. Turn the key switch "ON".
2. Put the brush switch in the "UP" position.
3. Turn the key switch "OFF".
4. Go to the side of the machine.
5. Pull downward on the brush or pad until it releases
from the flex plates. See figure 16.
How To Prepare the Machine For Operation
Figure 15
Figure 16

Nilfisk-ALTO SCRUBTEC R 571 Specifications

General

Brand	Nilfisk-ALTO
Model	SCRUBTEC R 571
Category	Scrubber
Language	English