Nilfisk ALTO Operator's Manual -
SCRUBTEC R Manual SteeringSCRUBTEC R Manual Steering
SCRUBTEC R Manual SteeringSCRUBTEC R Manual Steering
SCRUBTEC R Manual Steering Page -9-
Machine Controls and Features
Recovery Tank Float
The Scrubtec R is equipped with a float that shuts the
vacuum off when the recovery tank is full. The squeegee
will no longer pick up water. If this should happen, raise
the squeegee and empty the recovery tank.
The Traverse
The Scrubtec R is equipped with an electronically
controlled traverse system with variable speeds in
forward and reverse.
1. To traverse the machine, the power to the machine
must be turned on with the key switch and the
operator must be properly seated.
2. The traverse speed can be adjusted by varying the
pressure on the foot pedal.
NOTE: During reverse motion, the squeegee raises and
the solution flow stops automatically. Reverse also
reduces maximum traverse speed.
Brakes
The machine is equipped with an electronic braking
system. The electronic braking is activated automatically.
NOTE: During training, you should allow machine to
come to a full stop until you become familiar with
stopping distances required.
Parking Brake
The parking brake is activated automatically when the
machine comes to a stop. It disengages automatically
when you begin to traverse. The transaxle is equipped
with a manual brake release. NOTE: Machine will not
function when manual brake release is engaged. See
figure 2.
Reverse Alarm
The reverse alarm will sound intermittently and
automatically when the machine is in reverse.
Figure 2
To Next Page
Loading...
Need help?
General
