Nokia 6108 - Tone Settings; Enhancement Settings

Menu functions
55
Press Menu, and select Settings,
Display settings and Display
brightness. Scroll with and to
decrease and increase the brightness
level, and press OK to accept it.
Tone settings
Press Menu, and select Settings and
then Tone settings. You can find the
same settings in the Profiles menu,
see ”Profiles (Menu 4)” on page 48.
Note that the settings you make, will
change the settings in the active
profile.
Select Incoming call alert to choose
how the phone notifies you of an
incoming voice call. The options are
Ringing, Ascending, Ring once, Beep
once and Off.
Select Ringing tone for incoming
voice calls. To select ringing tones
that have been saved in the Gallery,
select Open gallery from the ringing
tone list.
Select Ringing volume and
Vibrating alert for incoming voice
calls and messages. The vibrating
alert does not work when the phone
is connected to a charger.
Tip: If you receive a ringing
tone via infrared connection
or by downloading, you can
save the ringing tone in the
Gallery.
Select Message alert tone to set the
alert tone for the incoming
messages, Keypad tones, or
Warning tones to set the phone to
sound tones for example, when the
battery is running out of power.
Select Alert for to set the phone to
ring only upon calls from phone
numbers that belong to a selected
caller group. Scroll to the caller
group you want or All calls and press
Mark.
Enhancement settings
The enhancement settings menu is
shown only if the phone is or has
been connected to a compatible
enhancement.
Press Menu, and select Settings and
Enhancement settings. You can
select Headset, Handsfree, or
Loopset, if a corresponding
compatible enhancement is or has
been connected to the phone.
•Select Default profile to select
the profile that you want to be
automatically activated when
you connect to the selected
enhancement. You can select
another profile while the
enhancement is connected.
•Select Automatic answer to set
the phone to answer an incoming
call automatically after five
seconds. If the Incoming call
alert is set to Beep once or Off,
automatic answer will not be in
use.