Boot Options
190
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
In remote deployments, this command provides additional security mechanism for the user.
The console can be disabled to prevent unauthorized system access.
The no form of this command enables the console.
Default no console-disabled
console-speed
Syntax console-speed baud-rate
no console-speed
Context bof
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command configures the console port baud rate.
When this command is issued to edit the BOF used for the most recent boot, the BOF and
the active configuration are changed immediately.
The no form of this command reverts to the default value.
Default 115200
Parameters baud-rate — The console port baud rate, expressed as a decimal integer.
Values 9600, 19200, 38400, 57600, 115200
4.12.2.1.4 Image and Configuration Management
persist
Syntax persist {on | off}
Context bof
Note: The console is always available for use when the device is booting up. This command
is applicable only after the TiMOS image (both.tim) is up and running successfully. If the
user executes this command in the BOF CLI context, the command takes effect only during
the next boot. A BOF save operation must be performed after executing the console-
disabled command.
To Next Page
Loading...
Need help?
General
