Boot Options
200
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
uplinkA-speed 10000
uplinkA-address 0
uplinkA-vlan 0
Default uplinkA-duplex full
Parameters full — Keyword to set the link to full duplex mode.
half — Keyword to set the link to half duplex mode.
uplinkB-duplex
Syntax uplinkB-duplex {full | half}
Context bof
Supported
Platforms
7210 SAS-M (network mode and access-uplink mode), 7210 SAS-Mxp, 7210 SAS-Sx/S 1/
10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and access-uplink mode)
Description This command configures the duplex mode of the uplinkB port when auto-negotiation is
disabled in the running configuration and the BOF.
This configuration command allows for the configuration of the duplex mode of the Ethernet
port. If the port is configured to auto-negotiate, this parameter will be ignored.
#uplinkB Port Settings:
uplinkB-port 1/1/26
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 10000
uplinkB-address 0
uplinkB-vlan 0
Default uplinkB-duplex full
Parameters full — Keyword to set the link to full duplex mode.
half — Keyword to set the link to half duplex mode.
Note: The uplinkB-autoneg command is not valid for 10gig ports. Therefore, whenever the
user selects 10gig ports as uplinkB-port, the uplinkB-autoneg command defaults to no
uplinkB-autoneg, speed as uplinkB-speed 10000, duplex as uplinkB-duplex full, as
shown in the following output sample.
To Next Page
Loading...
Need help?
General
