Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
Edition: 01 3HE 16132 AAAB TQZZA 199
Supported
Platforms
7210 SAS-M (network mode and access-uplink mode), 7210 SAS-Mxp, 7210 SAS-Sx/S 1/
10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and access-uplink mode)
Description This command enables speed and duplex auto-negotiation on the uplinkB port in the running
configuration and the BOF.
The no form of this command disables the auto-negotiate feature on this port.
#uplinkB Port Settings:
uplinkB-port 1/1/26
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 10000
uplinkB-address 0
uplinkB-vlan 0
Default uplinkB-autoneg
uplinkA-duplex
Syntax uplinkA-duplex {full | half}
Context bof
Supported
Platforms
7210 SAS-M (network mode and access-uplink mode), 7210 SAS-Mxp, 7210 SAS-Sx/S 1/
10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and access-uplink mode)
Description This command configures the duplex mode of the uplinkA port when auto-negotiation is
disabled in the running configuration and the BOF.
It also allows for the configuration of the duplex mode of the Ethernet port. If the port is
configured to auto-negotiate, this parameter will be ignored.
#uplinkA Port Settings:
uplinkA-port 1/1/26
no uplinkA-autoneg
uplinkA-duplex full
Note: The uplinkB-autoneg command is not valid for 10gig ports. Therefore, whenever the
user selects 10gig ports as uplinkB-port, the uplinkB-autoneg command defaults to no
uplinkB-autoneg, speed as uplinkB-speed 10000, duplex as uplinkB-duplex full, as shown
in the following output example.
Note: The uplinkA-autoneg command is not valid for 10gig ports, therefore, whenever the
user selects 10gig ports as uplinkA-port, the uplinkA-autoneg command is defaulted to
no uplinkA-autoneg, speed as uplinkA-speed 10000, duplex as uplinkA-duplex full, as
shown in the following output sample.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English