Nokia 7210 SAS-M - Page 204

Boot Options
204
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Default uplinkB-speed 1000
Parameters 10 — Keyword to set the link to 10 m/bps speed.
100 — Keyword to set the link to 100 m/bps speed.
1000 — Keyword to set the link to 1000 m/bps speed.
10000 — Keyword to set the link to 10000 m/bps speed.
uplinkA-vlan
Syntax uplinkA-vlan 0..4094
no uplinkA-vlan
Context bof
Supported
Platforms
7210 SAS-M (network mode and access-uplink mode), 7210 SAS-Mxp, 7210 SAS-Sx/S 1/
10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and access-uplink mode)
Description This command configures a VLAN ID to be used on uplinkA.
The no form of this command is used to send untagged packets on uplinkA.
Parameters 0...4094 — Specifies the VLAN ID.
Values 0 to 4049
uplinkB-vlan
Syntax uplinkB-vlan 0..4094
no uplinkB-vlan
Context bof
Supported
Platforms
7210 SAS-M (network mode and access-uplink mode), 7210 SAS-Mxp, 7210 SAS-Sx/S 1/
10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and access-uplink mode)
Description This command configures a VLAN ID to be used on uplinkB.
The no form of this command is used to send untagged packets on uplinkB.
Parameters 0...4094 — Specifies the VLAN ID.
Values 0 to 4049
eth-mgmt-address
Syntax [no] eth-mgmt-address ip-prefix/ip-prefix-length [active | standby]