Nokia 7210 SAS-M - Page 208

Boot Options
208
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
If the port is configured to Auto-negotiate, this parameter is ignored.
Default speed 100
speed 1000 (applicable only to 7210 SAS-R6 and 7210 SAS-R12)
Parameters 10 — Keyword to set the link to 10 M/bps speed.
100 — Keyword to set the link to 100 M/bps speed.
1000 — Keyword to set the link to 1000 M/bps speed (applicable only to 7210 SAS-R6
and 7210 SAS-R12).
host-type
Syntax host-type host-type
no host-type
Context bof
Supported
Platforms
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE (standalone and standalone-VC), and
7210 SAS-Sx 10/100GE
Description This command configures the host system.
When operating in satellite mode, the setting for the host-type BOF parameter must be
consistent with the value of the chassis-role parameter; otherwise, on reboot the node will
not boot up correctly. See BOF Chassis-Role and Host-Type Parameters for 7210 SAS-Sx 1/
10GE, 7210 SAS-S 1/10GE, 7210 SAS-Sx 10/100GE, and 7210 SAS-Mxp for more
information.
It is not necessary to configure the host-type value when the chassis role is set to
standalone.
For nodes that are destined to operate in a virtual chassis (VC) set up, it is not necessary to
configure the host-type value when the bootloader chassis-role parameter is set to
standalone-vc.
The no form of this command removes the host-type setting.
Default no host-type
Parameters host-type — Specifies the value of the host type for the system.
Values satellites | standalone | standalone-vc
satellites — The node boots up in satellite mode when the host-type parameter is set
to satellites and the chassis-role is set to satellite or factory-default.
standalone — The node boots up in standalone mode when the host-type parameter is
set to standalone.