Nokia 7210 SAS-M - Page 207

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
Edition: 01 3HE 16132 AAAB TQZZA 207
eth-mgmt-route
Syntax [no] eth-mgmt-route ip-prefix/ip-prefix-length next-hop ip-address
Context bof
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command configures a static route entry for the management Ethernet port in the
running configuration and the BOF.
This command allows manual configuration of static routing table entries. These static routes
are only used by traffic generated by the Ethernet port. To reduce configuration, manual
address aggregation should be applied where possible.
A static default (0.0.0.0 or 0) route cannot be configured on the management Ethernet port.
A maximum of ten static routes can be configured on the management Ethernet port.
The no form of this command deletes the static route.
Parameters ip-prefix\ip-prefix-length — Specifies the destination address of the static route in dotted
decimal notation.
Values ip-prefix|ip-prefix-length: ipv4-prefix a.b.c.d (host bits must be zero)
ipv4-prefix-le 0 to 32
ipv6-prefix - x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x - [0..FFFF]H
d - [0..255]D
ipv6-prefix-le - 0 to 128
next-hop ip-address — Specifies the next hop IP address used to reach the destination.
Values ipv4-address - a.b.c.d
ipv6-address - x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x - [0..FFFF]H
d - [0..255]D
eth-mgmt-speed
Syntax eth-mgmt-speed speed
Context bof
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command configures the speed for the management Ethernet port when auto-
negotiation is disabled in the running configuration and the BOF.