Boot Options
210
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Parameters port-id — Identifies the ports in the system using the notation chassis/slot/port-number.
For example, 1/1/1 refers to the front panel fixed port 1 on the chassis, and 1/2/1
refers to port 1 on the 2x10G MDA inserted into the system.
4.12.2.1.5 DNS Configuration Commands
dns-domain
Syntax dns-domain dns-name
no dns-domain
Context bof
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command configures the domain name used when performing DNS address resolution.
This is a required parameter if DNS address resolution is required. Only a single domain
name can be configured. If multiple domain statements are configured, the last one
encountered is used.
The no form of this command removes the domain name from the configuration.
Default no dns-domain
Parameters dns-name — Specifies the DNS domain name up to 32 characters.
primary-dns
Syntax primary-dns ip-address
no primary-dns [ip-address]
Context bof
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Note:
• The user can specify both ports to be the ones on the 2x10G MDA.
• The system ignores the value of the no-service-ports parameter if the use-expansion-
card-type value is m4-ds1-ces.
• It is recommended not to connect the ports configured as no-service-ports to another
device.
To Next Page
Loading...
Need help?
General
