7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
Edition: 01 3HE 16132 AAAB TQZZA 215
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
uplink-mode access-uplink
no-service-ports 1/1/24 1/1/2
use-expansion-card-type m2-xfp
no console-disabled
===============================================================================
A:7210-SAS>show#
Sample output for 7210 SAS-M (access-uplink mode)
*A:7210-SAS-M>bof# show bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@xxx.xxx.xxx.xx//tftpboot/apai/both.tim
primary-config ftp://*:*@xx.xxx.x.xxx/./images/mtuUplink.cfg
primary-dns xxx.xxx.xxx.xxx
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/24
uplinkA-address xx.xxx.x.xxx/24
uplinkA-autoneg
uplinkA-duplexfull
uplinkA-speed1000
uplinkA-vlan null
uplinkA-route xx.x.x.x/8 next-hop xx.xxx.x.x
uplinkA-route xx.xxx.x.x/16 next-hop xx.xxx.x.x
uplinkA-route xxx.xxx.x.x/16 next-hop xx.xxx.x.x
#System Settings:
wait 3
persist off
console-speed 115200
uplink-mode access-uplink
no console-disabled
===============================================================================
*A:7210-SAS-M>bof#
Sample output for 7210 SAS-Mxp
*A:7210SAS>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@xxx.xxx.xxx.xx/./pkhosla/SASM2/both.tim
primary-config ftp://*:*@xxx.xxx.xxx.xx/./pkhosla/SASM2/config2.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address xx.xxx.x.xxx/24 active
eth-mgmt-route xxx.x.x.x/8 next-hop xx.xxx.x.x
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100