Nokia 7210 SAS-M - Page 216

Boot Options
216
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
#uplinkA Port Settings:
uplinkA-port 1/1/1
uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 1000
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/2
uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 1000
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
uplink-mode network
no console-disabled
===============================================================================
*A:7210SAS>show#
Sample output for 7210 SAS-R6
A:dut-a>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@10.135.23.81/./images/dut-r/
primary-config ftp://*:*@10.135.23.81/./images/dut-r/dut-r.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address 10.135.23.163/24 active
eth-mgmt-address 10.135.23.164/24 standby
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 1000
#System Settings:
wait 3
persist on
console-speed 115200
no console-disabled
===============================================================================
A:dut-a>show#
Sample output for 7210 SAS-Sx/S 1/10GE
*A7210SAS>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@xx.xxx.x.xx/./images/SASS/hops-both.tim
primary-config cf1:\bala_default_config.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address xx.xxx.xx.xx/24 active