Nokia 7210 SAS-M - Page 342

System Management
342
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
• SAPs
• Egress
• Ingress
SAPs
• If a TOD Suite is assigned to a SAP, statistics collection are not collected for that
SAP.
• When an item is configured both on SAP level and in the TOD suite assigned to
the SAP, the TOD-suite defined value takes precedence.
• A policy or filter assignment configured directly on a SAP has a lower priority
than any assignment in a TOD Suite. Therefore, it is possible that a new direct
configuration has no immediate effect. If the configuration is made by CLI, a
warning is given.
Egress
This command is an enhancement for specific egress policies. Use this command to
create time-range based associations of previously created filter lists, QoS and
scheduler policies. Multiple policies may be included and each must be assigned a
different priority; in case time-ranges overlap, the priority will be used to determine
the prevailing policy. Only a single reference to a policy may be included without a
time-range.
Filters
In a TOD suite, filters that have entries with time-ranges may not be selected.
Similarly, filter entries with a time-range may not be created while a TOD suite refers
to that filter. QoS policies and filters referred to by a TOD suite must have scope
“template” (default).
Use the following syntax to configure TOD-suite egress parameters.
CLI Syntax: config>system>cron
tod-suite tod-suite-name create
egress
filter ip ip-filter-id [time-range time-range-
name] [priority priority]
filter ipv6 ipv6-filter-id [time-range time-
range-name] [priority priority]
filter mac mac-filter-id[time-range time-
range-name] [priority priority]