7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 395
clli-code
Syntax clli-code clli-code
no clli-code
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command creates a Common Language Location Identifier (CLLI) code string for the
router. A CLLI code is an 11-character standardized geographic identifier that uniquely
identifies geographic locations and certain functional categories of equipment unique to the
telecommunications industry.
No CLLI validity checks other than truncating or padding the string to eleven characters are
performed.
Only one CLLI code can be configured, if multiple CLLI codes are configured the last one
entered overwrites the previous entry.
The no form of this command removes the CLLI code.
Parameters clli-code — Specifies the 11 character string CLLI code. Any printable, seven bit ASCII
characters can be used within the string. If the string contains special characters (#,
$, spaces, and so on), the entire string must be enclosed within double quotes. If
more than 11 characters are entered, the string is truncated. If less than 11
characters are entered the string is padded with spaces.
config-backup
Syntax config-backup count
no config-backup
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the maximum number of backup versions maintained for
configuration files and BOF.
For example, assume count is set to 5, and the configuration file is called xyz.cfg. When a
save command is executed, the file xyz.cfg is saved with a .1 extension. Each subsequent
config-backup command increments the numeric extension until the maximum count is
reached.
To Next Page
Loading...
Need help?
General
