System Management
396
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
xyz.cfg
xyz.cfg.1
xyz.cfg.2
xyz.cfg.3
xyz.cfg.4
xyz.cfg.5
xyz.ndx
Each persistent index file is updated at the same time as the associated configuration file.
When the index file is updated, the save is performed to xyz.cfg and the index file is created
as xyz.ndx. Synchronization between the active and standby is performed for all
configurations and their associated persistent index files.
The no form of this command reverts the configuration to the default value.
Default 5
Parameters count — Specifies the maximum number of backup revisions.
Values 1 to 9
contact
Syntax contact contact-name
no contact
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command creates a text string that identifies the contact name for the device.
Only one contact can be configured, if multiple contacts are configured the last one entered
will overwrite the previous entry.
The no form of this command reverts to the default.
Parameters contact-name — Specifies the contact name character string. The string may be up to 80
characters. Any printable, seven-bit ASCII characters can be used within the string.
If the string contains special characters (#, $, spaces, and so on), the entire string
must be enclosed within double quotes.
coordinates
Syntax coordinates coordinates
no coordinates
To Next Page
Loading...
Need help?
General
