Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 397
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command creates a text string that identifies the system coordinates for the device
location. For example, the command coordinates “37.390 -122.0550" is read as latitude
37.390 north and longitude 122.0550 west.
Only one set of coordinates can be configured. If multiple coordinates are configured, the last
one entered overwrites the previous entry.
The no form of this command reverts to the default value.
Parameters coordinates — Specifies the coordinates describing the device location character string.
The string may be up to 80 characters. Any printable, seven-bit ASCII characters can
be used within the string. If the string contains special characters (#, $, spaces, and
so on), the entire string must be enclosed within double quotes. If the coordinates are
subsequently used by an algorithm that locates the exact position of this node then
the string must match the requirements of the algorithm.
lacp-system-priority
Syntax lacp-system-priority lacp-system-priority
no lacp-system-priority
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the Link Aggregation Control Protocol (LACP) system priority on
aggregated Ethernet interfaces. LACP allows the operator to aggregate multiple physical
interfaces to form one logical interface.
Default 32768
Parameters lacp-system-priority — Specifies the LACP system priority.
Values 1 to 65535
location
Syntax location location
no location
Context config>system

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English