Nokia 7210 SAS-M User Manual

System Management
398
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command creates a text string that identifies the system location for the device.
Only one location can be configured. If multiple locations are configured, the last one entered
overwrites the previous entry.
The no form of this command reverts to the default value.
Parameters location — Specifies the location as a character string. The string may be up to 80
characters. Any printable, seven-bit ASCII characters can be used within the string.
If the string contains special characters (#, $, spaces, and so on), the entire string
must be enclosed within double quotes.
login-control
Syntax login-control
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables the context to configure login control.
name
Syntax name system-name
no name
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command creates a system name string for the device.
For example, system-name parameter ALA-1 for the name command configures the device
name as ALA-1.
Only one system name can be configured. If multiple system names are configured, the last
one encountered overwrites the previous entry.
The no form of this command reverts to the default value.
Default the default system name is set to the chassis serial number which is read from the backplane
EEPROM

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English