System Management
420
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
startup-alarm alarm-type — Specifies the alarm that may be sent when this alarm is first
created. If the first sample is greater than or equal to the rising threshold value and
startup-alarm is equal to rising or either, a single rising threshold crossing event is
generated. If the first sample is less than or equal to the falling threshold value and
startup-alarm is equal to falling or either, a single falling threshold crossing event
is generated.
Values rising, falling, either
Default either
rmon
Syntax rmon
Context config>system>thresholds
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables the context to configure generic RMON alarms and events.
Generic RMON alarms can be created on any SNMP object-ID that is valid for RMON
monitoring (for example, an integer-based datatype).
The configuration of an event controls the generation and notification of threshold crossing
events configured with the alarm command.
alarm
Syntax alarm rmon-alarm-id variable-oid oid-string interval seconds [sample-type] [startup-alarm
alarm-type] [rising-event rmon-event-id rising-threshold threshold] [falling-event
rmon-event-id falling threshold threshold] [owner owner-string]
no alarm rmon-alarm-id
Context config>system>thresholds>rmon
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures an entry in the RMON-MIB alarm Table. This command controls
the monitoring and triggering of threshold crossing events. In order for notification or logging
of a threshold crossing event to occur there must be at least one associated rmon>event
configured.
To Next Page
Loading...
